Any time two pieces of metal that fluids or air flow through meet there is potential for leaks.  A gasket is placed between these two pieces of metal before they are fastened together, which then fills in the gaps and prevents leaks.  It’s a simple concept, but a lot of chemical and mechanical engineering has gone into gasket design, as well as designing the material they are made out of, to ensure gaskets can hold up to the demands of modern engines, which are very different than they used to be.  Of course, the older a vehicle is the greater the need for specialized gasket technologies, since as an engine ages the potential for leaks is much greater. Fel-Pro gaskets have the manufacturing capabilities and resources of Federal-Mogul behind them, inclu...

Installing an automatic transmission pan gasket can be a tedious and aggravating task, as holding the gasket in place is difficult while you are raising the pan to your vehicle.  Fel-Pro has solved this sticky problem for you!  The Fel-Pro A/T pan gaskets use the unique Hole-Locks design, which helps to make installation faster and easier, while also providing a better seal.  Bolt holes in the gasket are just a little smaller than the bolts, so that the gasket and bolts are held in place while the pan is raised to your vehicle.  The Hole-Locks design also allows you to avoid using contact adhesive on the pan gasket, which could cause problems if it were to get inside the transmission casing. Federal-Mogul Fel-Pro is the dominant brand of replacement sea...